Synchronous commands
When a synchronous command is received, if it is valid, the system reply with
<command valid="true" [Command reply informations] />
Here the list of all synchronous commands:
- Module status
- Machine status
- Get Fonts
- Get MAC Address
- Interface Status
- Scaps License
- Get Entities
- Get Layouts
- Get Model
- Transport Status
- Get Opto Status
- Get Motor Speed
- Set Motor Speed
- Get Motor Offset
- Set Motor Offset
- Connect to chip
- Transmit to chip
- Connect to RFID
- Transmit to RFID
- Laser Status
- Get Diode Hours
- Get Laser Configuration
- Set Laser Configuration
- Set Volatile Configuration
- Get Laser Analogs
- Reset Laser
- Get Interlock
- Get Image
- Create XY Autoposition
- Perform XY Autoposition
- Get XY Patterns
- Delete XY Pattern
- Get Camera Correlation
- Set Camera Correlation
- Create OCR Operation
- Perform OCR Operation
- Insert OCR Key
- Get OCR Patterns
- Delete OCR Pattern
- Create Barcode Operation
- Perform Barcode Operation
- Insert Barcode Key
- Get Barcode Patterns
- Delete Barcode Pattern
- Write Message on display
- Get Angle
- Get Version